Luxembourgguidelines.org – How To Make A Corncob Pipe. Corncob are corn waste that is easy to find in Indonesia. The reason is that corn cob waste contains high levels of lignocellulose, so it can be processed into liquid smoke. So, how do you make corncob pipe? Come on, see the explanation in the article below.
How To Make A Cornb Pipe
The following are several ways that can be done in the manufacturing process, including:
# Step 1
- The first is to prepare the tools and materials first. Starting from 1 ear of corn, pocket knife, wooden branch, drill, tobacco and matches.
- The second is to shave the shaft with a pocket knife. You can ensure that the ears of corn you use are wide and have lots of pith. Then, break the cob in half using your hands or you can cut it to the desired size with a penknife.
- Third, you want to be able to make the cobs dry and firm. Typically, corn cob pipe makers let the cobs dry for about two years. However, you can put it in the oven and use a dehydrator to speed up the process. Then, you can leave it for one week after the baking process at 100 degrees for several hours.
- Fourth is to dig out the core with a pocket knife to form a bowl. If possible, you can make the depth about one inch. Then, the size of the bowl must be as wide as the pith without making the pipe walls too thin. Then, the slim walls will make your hands hot during the process of lighting the tobacco. For this reason, you have to try to keep it looking thick.
# Step 2
- Fifth, at the bottom of the bowl, drill a narrow hole through the pith towards the bottom position of the pipe. If you are not using power tools during the project, you can heat the metal hangers and holes. through the central pith.
- Sixth, while letting the bowl dry, you can make a pipe stem. Then, there are several options for not using a lathe to turn a piece of wood. If you have access to a narrow strip of bamboo, you can use it. Next, the process of making holes is very easy to do with a metal hanger that is heated to a hotter condition using a drill. This fits perfectly in the hole that will be cut near the base of the cob. After that, use a pocket knife to bevel one side of the stem to a point. So, the use of this side will be pushed into the cob.
- Seventh, you can drill a hole at the top of the base of the corn cob until it meets the pith hole. Then, make sure the hole is slightly smaller than the stem you have. Then, press the stem into the cob and align the hole in the stem with the hole in the pith. Next, all you need is your preferred tobacco and a lighter.
That is the interesting explanation above that can be conveyed about how to make corncob pipe. Hopefully after reading the discussion in this article, you can understand it well, use it as an additional reference, increase your knowledge and insight. And in the future, it can be useful and can apply this knowledge in everyday life.